Levoite™ Edge Rule for Woodworking
Measuring the narrow edge of stock with typical rules is a little awkward. Getting the rule parallel to the stock and leaving yourself room to make a tic mark can become quite a juggling act. Working on the face of a piece is usually a little easier, but you can still struggle to keep the rule parallel to your work. Levoite Precision Edge Rule simplifies your life by wrapping around the edge of your stock and giving you an accurate scale on both sides. Whether you're working on the edge or the face, the corner of the Edge Rule always keeps you properly aligned.
Mid-Field Measurements Even when youre not working at the edge of your stock youll still find the Edge Rule handy. The profiled shape makes it easier to move around onyour stock than a thin flat rule and the beveled edges get the scale right next to your stock where you need it.
Here are Just a Few of the Edge Rule s Tricks
1. Measurements from Inside Corners Hardware installation usually calls for a measurement referenced from an intersecting cross-member...like the rails and stiles of a cabinetface frame. The Edge Rule drops in perfectly zeroed out to the intersection and aligned to the stock.
2. Marking Edge and Face at the Same Dimension Place the desired dimension at the end of your board and mark at the end of your Edge Rule on both the face and edge. Usethe optional Edge Rule Stop to accurately and easily repeat that setting as many times as needed.